OO Gauge Pit Head Winding Shed
This winding shed shown is with a NESH® Pit Head (not Included)
00 Colliery Pit Head 7426898250540
The Winding Shed separates into 3 parts for ease of access
Ground floor with stairs
1st Floor winding gear & control room/office
Width : 64mm
Height : 126mm
In deep mines, the winding gear was used to bring the coal to the surface, as well as to allow men to reach the pit face. In addition, the cages could bring down necessary supplies and machines to the pit bottom.
Cages are normally suspended on a steel winding rope, attached to the drum of the winding engine via a pulley on the headgear . The cage is normally supported underneath by cage chains – four corner chains and two safety chains.
The headgears are iron and brick towers that stand over mine shafts.
On line instructions for construction
Requires the use of glue and craft knife (not supplied)
Supplied unpainted ready for decorating in your choice of colours
All figures/models Shown are for illustration only & not included
supplied as a kit, requires minimal assembly using PVA glue
There are no reviews yet.